2
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
2.33
6. Install the two mounting bolts. Torque fasteners to
specification.
TORQUE
Tensioner Mounting Bolts:
7 ft-lb (10 Nm)
7. Install the plunger bolt. Torque fastener to
specification.
TORQUE
Plunger Bolt:
15 ft-lb (20 Nm)
SPARK ARRESTOR
The spark arrestor should be cleaned after every oil
change to remove accumulated carbon. A plugged spark
arrestor will affect engine performance. Replace a
cracked or damaged spark arrestor before running the
vehicle.
NOTE
The spark arrestor should be cleaned each time the
machine is submerged in water/mud, and after every oil
change.
1. Remove the spark arrestor retaining fasteners
q
.
2. Remove the arrestor from the end of the muffler.
3. Use a non-synthetic brush to clean the screen
w
on
the arrestor. If necessary, blow debris from the screen
with compressed air.
4. Inspect the screen for wear and damage. Replace if
damaged.
5. Reinstall the spark arrestor. Torque fasteners to
specification.
TORQUE
Spark Arrestor Fasteners:
8 ft-lb (11 Nm)
MAINTENANCE
To Next Page
Loading...
Need help?
General
