8
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
8.7
POWER STEERING UNIT REMOVAL
1. Remove the upper steering shaft, pivot tube and
steering wheel from the vehicle as an assembly.
Refer to .
CAUTION
Striking the steering wheel or steering shaft while
installed in the vehicle can permanently damage the
EPS unit and cause a Power Steering Fault.
2. Disconnect the two electrical harnesses
q
from the
power steering unit .
3. Remove the pinch bolt
w
retaining the lower steering
shaft to the power steering unit .
4. While supporting the power steering unit, remove the
four nuts
e
from the mount bracket.
5. Carefully remove the power steering unit and mount
bracket from the vehicle as an assembly.
IMPORTANT
Power steering units have a steering position sensor.
Avoid spinning steering shafts after removing power
steering unit from the vehicle.
STEERING / SUSPENSION