To Next Page

To Previous Page

8.6

9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual

STEERING WHEEL / HUB ADAPTER

REMOVAL

STEERING WHEEL REMOVAL

1. Remove the steering wheel fasteners and remove the

steering wheel.

HUB ADAPTER REMOVAL

1. Remove upper steering shaft, and pivot tube as an

assembly before attempting to remove the hub

adapter. Refer to Upper Steering Shaft Removal page

8.5.

CAUTION

Striking the steering wheel or steering shaft while

installed on the vehicle can permanently damage the

EPS unit, and cause a power steering fault.

2. Loosen the nut

and back it half way off the steering

shaft.

3. Place the assembly in a vise.

4. Using a large bronze drift and hammer, strike the

steering shaft nut to pop the hub adapter

off the

shaft taper.

5. Once the hub adapter pops loose, completely remove

the nut and lift the hub adapter off the shaft.

STEERING / SUSPENSION

Polaris RZR XP User Manual

Questions and Answers: