Scalar DLC Reference Guide 257
387 The accessor dropped a cartridge
388 Could not erase EEPROM
389 Could not program EEPROM
390 Cartridge in gripper at power-on
391 Component failure
392 Gripper error
393 The accessor could not move on the vertical (Y) axis
394 Could not home the vertical (Y) axis
395 The accessor could not move on the horizontal (X) axis
396 Could not home the horizontal (X) axis
397 The accessor lost power
398 Internal target failure
399 A drive did not load or unload a tape
400 Cannot lock the I/E station
401 Cannot unlock the I/E station
402 Label too short, too long or duplicate
403 Cannot read a barcode label due to scanner problem
404 Firmware error
405 Parameter list length error (Illegal Request).
406 Illegal operation code in CDB (Illegal Request).
407 Invalid element address in CDB (Illegal Request).
408 Attempt to write a read only buffer (Illegal Request).
409 Illegal LUN (Illegal Request).
410 Invalid field in Parameter List (Illegal Request).
411 Invalid parameter in Parameter List (Illegal Request).
412 Parameter data checksum failure (Illegal Request).
413 Incompatible media installed (Illegal Request).
414 Source of MOVE MEDIUM command cannot be accessor (Illegal Request).
415 Cartridge stuck in tape drive (Illegal Request).
416 Source cartridge loaded into tape drive and not accessible (Illegal Request).
417 Media type does not match destination media type (Illegal Request).
418 Invalid bit in "Identify" message (Illegal Request).
Table 35 Error Codes (Continued)
Error Code Description
To Next Page
Loading...
Need help?
General