258 Application Notes
419 Incorrect LUN configuration (Illegal Request).
420 Firmware detected an internal logic failure (Illegal Request).
421 Cartridge rejected in the Insert/Eject station because it was not properly loaded (Illegal
Request).
422 Cell status and barcode questionable (Illegal Request).
423 Medium removal prevented because storage element is unavailable (Illegal Request).
424 Cartridge magazine is not installed (Illegal Request).
425 Data transport device is not installed (Illegal Request).
426 Data transfer element is varied offline (Illegal Request).
427 Message received at inappropriate time (Abort error).
428 Host rejected "Identify" message sent for reselection (Abort error).
429 Message system was disabled during parity error detection on SCSI bus (Abort error).
430 Received an "Initiator Detected Error" or initiator rejected "Restore Data Pointer" (Abort
error).
431 Disconnect during command processing (Abort error).
432 The command was cancelled due to a state change (Abort error).
433 Destination element full for MOVE MEDIUM command (Illegal Request).
434 Source element empty for MOVE MEDIUM command (Illegal Request).
Table 35 Error Codes (Continued)
Error Code Description
To Next Page
Loading...
Need help?
General