5-144 Menus and Commands
6-00054-02 Rev A
If Y is selected for the Accept parameter, the Include
Drives Dialog appears. See Figure 5-207. Otherwise, the
changed parameters continue to display but no action is
taken.
Figure 5-207 Include Drives Dialog
Parameter Value
Include Drives Y indicates that the drives will
be included in the cycling of
the cartridges.
N indicates that the drives will
not be included in the cycling
of the cartridges.
Accept Y to accept the changes
N to reject the changes
If Y is selected for the Accept parameter value, the
Response Dialog appears. See Figure 5-208. Otherwise,
the changed parameters continue to display but no action
is taken.
Figure 5-208 Response Dialog
Parameter Value
Cycle Indicates the number of
completed test cycles of the
requested cycles.
Status Shows the status of the
indicated cycle (Running,
Completed, Error, Canceled).
Cancel Y to cancel the test
N to continue running the test
Include drives: Y
Accept: Y
Demo with Drives
Cycle :5 of 9
Status:Running
Cancel: N<
Note
If the operation
stops, the Cancel
parameter no
longer displays.
To Next Page
Loading...
