Quantum Scalar 1000 - Operator Intervention Messages

Operator Intervention Messages 7-23
22 June 2004
Operator Intervention Messages
Table 7-2 describes some of the operator intervention
messages. Each intervention message is composed of four
lines. The third and/or fourth lines may contain variable
information specific to the message. For SAC indications, refer
to Service Action Codes on page 7-3. For Code error modifiers,
refer to the Scalar 1000 Maintenance Guide.
Table 7-2 Operator Intervention Messages
Message Lines Variables
Alert not found.
Press Enter.
None
WARNING!
The accessor could
not be parked.
[OK]
None
WARNING!
Moving tapes may
corrupt partitions.
Continue: %X
%X = Y to continue
-=>ERROR!<=-
Initialization Error
Code: 0x%X
%X = 8 digits hex
error modifier
-=>PERM ERROR!<=-
CALL FOR SERVICE
SAC :%X
Code:0x%Y
%X = 2 digit hex
%Y = 8 digit hex
error modifier
-=>PERM ERROR!<=-
SYSTEM WILL REBOOT
SAC :%X
Code:0x%Y
%X = 2 digit hex
%Y = 8 digit hex
error modifier
->SYSTEM REBOOTED<-
NEW CODE LOADED
Version %XXXX.%YYYYY
current version
%X = 4 digit major rev
%Y = 5 digit minor rev
->SYSTEM REBOOTED<-
RECOVERED FROM ERROR
SAC :%X
Code:0x%Y
%X = 2 digit hex
%Y = 8 digit hex
error modifier