5-86 Menus and Commands
6-00054-02 Rev A
Emulate Dialog
Path: Main Menu Setup Menu Library
Submenu Emulate Dialog
Use the Emulate Dialog to change the library operating
mode. Different emulation modes cause the library to
respond to SCSI INQUIRY commands in a manner consistent
with the listed library emulation type. Changes will NOT take
effect until the library power is cycled. See Figure 5-115.
Figure 5-115 Emulate Dialog
Parameter Value
Library type NATIVE
STK 9710
EXB 480
EMASS
Accept Y to accept changes
N to reject changes
If Y is selected for the Accept parameter value, the screen
updates to reflect the changes. Otherwise, the changed
parameters continue to display but no action is taken.
Select library type :
NATIVE <
Accept : N
Note
Refer to the
Scalar 1000 SCSI
Reference Manual
for all command
processing. Refer
to Associated
Documents on
page 1-4 for more
information.
To Next Page
Loading...
