Using Cleaning Cartridges 6-27
22 June 2004
• The Expired Tapes method. Refer to Expired Tapes on page
5-55 for more information.
• The Coordinate Dialog method. Refer to By Coordinate
Dialog on page 5-57 for more information.
• The Volser Dialog method. Refer to By Volser Dialog on
page 5-60 for more information.
Declaring a Cleaning Cartridge
If a cleaning cartridge has been introduced into the library by
means other than Insert Cleaning Tape, use this menu to
inform the library that this tape is a Cleaning Tape. For further
information, refer to Media Dialog on page 5-94.
Path:
Setup Menu Cleaning Submenu Media
Dialog
Step 1 Follow the path and the Media Dialog appears.
See Figure 6-10.
Figure 6-10 Media Dialog
Step 2 Enter the Media Type (DLT, SDLT, AIT, LTO, 3480/
90E, 3590, NCTP), BC (Barcode of cleaning tape you
want to declare. Use an
* for ranges of barcodes).
See Figure 6-11.
Figure 6-11 Selected Cleaning Tape
Note
It is suggested that
cleaning tapes have
white labels and the
first three letters for
the Volser number
are CLN.
Media Type: LTO <
BC : AAAAAA
Continue: N
Media Type: LTO <
BC : CLN001
Continue: N
To Next Page
Loading...
Need help?
General