Inserting Media 6-7
22 June 2004
Issue the Move Media command from the Operator
Panel. Refer to Move Media Dialog on page 5-39.
The Accessor moves the cartridge to the requested storage
cell location.
Manually Inserting Cartridges
There are two levels of access control. The first level is a
mechanical key lock. The second level is password protection
invoked by the host SCSI Mode Select command, LCD Page
Security option, or through the Operator Panel Security
option.
To manually insert media, follow this procedure.
If enabled, all locks must be disabled before the procedure
will succeed.
Step 1 If the password option is enabled, enter the
password.
Step 2 Use the Operator Panel to place the library
into the NOT READY state. Refer to Mode Dialog on
page 5-10.
The Accessor completes any current task and returns to
the home position.
Step 3 Using the key, unlock and open the library door.
Step 4 Place the cartridge into the desired storage cell.
Step 5 Close and lock the door.
Step 6 Place the library in the READY state. Refer to Mode
Dialog on page 5-10.
Step 7 If the library does not perform an inventory within
one minute, execute a SCSI INITIALIZE
ELEMENT STATUS or a library Operator Panel
Inventory command.
STATIC
SENSITIVE
Caution
To Next Page
Loading...
