Quantum Scalar 1000 - Ejecting Media; Using the Insert;Eject Station

6-8 Processing Media
6-00054-02 Rev A
Ejecting Media
Removing media from the library is accomplished by using
the I/E Station. Alternately, the cartridge could be manually
removed from a specific storage cell location by the operator.
Using the Insert/Eject Station
Using the I/E Station to remove cartridges does not disrupt
library operations. To remove cartridges through the I/E
Station, follow this procedure.
Step 1 Issue a SCSI MOVE MEDIUM command from the
host with the source storage cell and the destination
I/E Station cell.
— or —
Execute the Eject command from the Operator
Panel. Refer to Eject Dialog on page 5-52.
The I/E Station is locked while the Accessor moves the
cartridge. After the move completes, the
I/E Station unlocks.
Step 2 Pull on the handle to open the I/E Station.
Step 3 Remove the cartridge magazine from the
I/E Station.
Step 4 Remove the cartridge from the storage cell.
Step 5 Replace the cartridge magazine into the
I/E Station.
Step 6 Close the I/E Station.