Quantum Scalar 1000 - Setting up the RMU

Using the Remote Management Unit 4-13
22 June 2004
Once you have this information, input it to the RMU by means
of the Operator Panel. For more information, see the
instructions that follow.
Setting up the RMU
Once you have obtained a network address for the RMU, enter
this information into the RMU by means of the library
Operator Panel.
To configure the RMU
Step 1 From Operator Panel Main Menu, select Setup
Library RMU.
The RMU Submenu is shown.
Step 2 Select Name.
The Name Dialog is shown.
Step 3 Enter the hostname using the Up, Down, and Next
buttons.
Step 4 Select Y to accept the changes.
Step 5 Select IP.
The IP Dialog is shown.
>Name...
IP...
Name : webfoot3
Accept : N
IP : 100<100.100.100
Sub: 255.255.255.255
Gat: 100.100.100.100
Accept: N