Setup Menu 5-91
22 June 2004
Drives Dialog
Path: Main Menu Setup Menu Drives Dialog
Use the Drives Dialog to modify the SCSI ID for all drive
models except TD3610, 3590-B1A, 3590-E1A, Ultrium-TD1
(LTO-1), and Ultrium-TD2 (LTO-2).
See Figure 5-120.
Figure 5-120 Drives Dialog
Parameter Value
Drive ID Override Enabled allows the operator to
enable the setting of SCSI ID
for supported drives
Disabled prevents the library
from setting the SCSI ID for
supported drives
Set Drive ID Y to view and set the drive
SCSI ID
N to not change the drive SCSI
ID
Accept Y to accept changes
N to reject changes
If Enabled is selected or was previously selected for the
Drive ID Override parameter and Y is selected for the Set
Drive Id and the Accept parameters, the SCSI ID Dialog
appears. Refer to Figure 5-121 on page 5-92.
If Drive ID Override is disabled and Y is selected for
Accept, the changed parameters continue to display but
no new screen action is displayed.
— or —
If N is selected for the Accept parameter, the changed
parameters continue to display but no action is taken.
Drive ID Override:
Enabled <
Set Drive ID: N
Accept: N
Note
Drive ID
Override does
not work on LTO
drives..
To Next Page
Loading...
Need help?
General