Quantum Scalar 1000 User Manual

7-18 Error Messages
6-00054-02 Rev A
85 X-Axis failed to reach target.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
86 The first full speed move command issued when the Accessor is at home
position failed.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
87 The Accessor cannot move away from the X-Axis home position.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
88 The Accessor cannot move away from the Y-Axis home position.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
90 An LSC1 card was detected by the Library firmware when an LSC2 card is
required for this Library configuration to operate.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
91 An LMC1 card was detected by the Library firmware when an LMC3 card is
required for this Library configuration to operate.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
92 An LBI1 card was detected by the Library firmware when an LBI2 card is
required for this Library configuration to operate.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
Table 7-1 SAC Reporting (Continued)
Reported
SAC
Perform these actions

Quantum Scalar 1000 Specifications

General

Brand	Quantum
Model	Scalar 1000
Category	Storage
Language	English