Service Action Codes 7-19
22 June 2004
93 A failure was detected in the drive communication hardware within the
Library. The Library cannot communicate with one or more tape drives (note
the physical location of the failing tape drive. This information is presented
with the SAC).
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
94 Communication was established between the Library and the tape drive but
the Library cannot determine the status of a particular tape drive.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
96 The Library detected a tape drive hardware failure.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
97 Firmware detected that the LGR card installed in the Library can not be used
with this level of firmware. One of the following conditions exist:
• A new level of firmware is installed in a Library with an old-style gripper and
old style LGR card.
• The library is upgraded to the new style gripper and LGR card but does not
have the latest level of firmware installed.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
A0 An error has been detected in the communication path between the Library
Controller and the RMU.
Action 1
Verify the Trace output is set to NONE/RMU (Main Menu
Setup Library Trace Dialog). Refer to Trace Dialog on page 5-78 for
more information.
Action 2
If the problem is not corrected or persists, contact ATAC. For contact
information, refer to ADIC Technical Assistance Center on page 1-5.
Table 7-1 SAC Reporting (Continued)
Reported
SAC
Perform these actions
To Next Page
Loading...
Need help?
General