Quantum Scalar 1000 User Manual

7-20 Error Messages
6-00054-02 Rev A
D0 The Library detected that one of the DC Power supplies has failed. This error
condition only occurs in Libraries equipped with the Redundant DC Power
Supplies Feature.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
D1 The Library detected that AC input to one bank of the DC Power supplies is
missing. This error condition only occurs in Libraries equipped with the
Redundant DC Power Supplies Feature.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F0 Failures were detected while running the diagnostic loop test from the LSC
card to the LMC card.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F1 Failures were detected while running the diagnostic loop test from the LSC
card to the LPN1 card.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F2 Failures were detected while running the diagnostic loop test from the LSC
card to the LGR card.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F3 Failures were detected while running the diagnostic loop test from the LSC
card to all sensors on the Gripper Assembly.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
Table 7-1 SAC Reporting (Continued)
Reported
SAC
Perform these actions

Quantum Scalar 1000 Specifications

General

Brand	Quantum
Model	Scalar 1000
Category	Storage
Language	English