Quantum Scalar 1000 - Page 273

Service Action Codes 7-21
22 June 2004
F4 Failures were detected while running the diagnostic loop test from the LSC
card to all sensors on the Insert/Eject Station.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F5 Failures were detected while running the diagnostic loop test from the LSC
card to the X-Axis home sensor.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F6 Failures were detected while running the diagnostic loop test from the LSC
card to the Y-Axis home sensor.
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F7 Failures detected in the LSC card during Power On Self Test (POST).
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F8 Failures detected in the LMC card during Power On Self Test (POST).
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
F9 Failures detected in the LGR card during Power On Self Test (POST).
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
FA Failures detected in the LAM1 card during Power On Self Test (POST).
Action 1
Contact ATAC. For contact information, refer to ADIC Technical Assistance
Center on page 1-5.
Table 7-1 SAC Reporting (Continued)
Reported
SAC
Perform these actions