R&S FSV3000 Series - Page 229

Measurements and Results
R&S
®
FSVA3000/ R&S
®
FSV3000
229User Manual 1178.8520.02 ─ 01
Power Reference Type ...............................................................................................229
Channel Power Settings .............................................................................................229
└ Tx Bandwidth ............................................................................................... 229
└ RRC Filter State ...........................................................................................230
└ Alpha: ...........................................................................................................230
Power Reference Type
Defines how the reference power is calculated.
"Channel Power"
Measures the channel power within the reference range using the
integration bandwidth method. Additional settings can be configured
for this method.
(See also "IBW method" on page 146)
"Peak Power"
Determines the peak power within the reference range.
Remote command:
[SENSe:]ESPectrum<sb>:RTYPe on page 809
Channel Power Settings
If the "Power Reference Type:" "Channel Power" was selected, additional parameters
can be configured.
Tx Bandwidth ← Channel Power Settings
Defines the bandwidth used for measuring the channel power, with:
Minimum span ≤ "Tx Bandwidth" ≤ of reference range
Remote command:
[SENSe:]ESPectrum<sb>:BWID on page 808
Spectrum Emission Mask (SEM) Measurement