R&S FSV3000 Series - Page 315

Common Measurement Settings
R&S
®
FSVA3000/ R&S
®
FSV3000
315User Manual 1178.8520.02 ─ 01
Name...........................................................................................................................315
Serial Number............................................................................................................. 315
Part Number................................................................................................................315
Type............................................................................................................................ 315
Mode........................................................................................................................... 315
Common Mode Offset / Diff. Mode Offset / P Offset / N Offset / ................................ 315
Attenuation..................................................................................................................316
Microbutton Action ..................................................................................................... 316
Name
Probe name
Remote command:
[SENSe:]PROBe<pb>:SETup:NAME? on page 927
Serial Number
Serial number of the probe
Remote command:
[SENSe:]PROBe<pb>:ID:SRNumber? on page 925
Part Number
Rohde & Schwarz part number
Remote command:
[SENSe:]PROBe<pb>:ID:PARTnumber? on page 925
Type
Type of probe:
●
Single-ended
●
Differential
●
Active Modular
Remote command:
[SENSe:]PROBe<pb>:SETup:TYPE? on page 929
Mode
Mode for multi-mode modular probes. Determines which voltage is measured.
"DM-mode"
Voltage between the positive and negative input terminal
"CM-mode"
Mean voltage between the positive and negative input terminal vs.
ground
"P-mode"
Voltage between the positive input terminal and ground
"N-mode"
Voltage between the negative input terminal and ground
Remote command:
[SENSe:]PROBe<pb>:SETup:PMODe on page 928
Common Mode Offset / Diff. Mode Offset / P Offset / N Offset /
Sets the offset for the probe, depending on the used mode (CM and DM mode both
use the "Common Mode Offset"). The setting is only available if a differential (R&S RT-
ZD) or modular (R&S RT-ZM) probe is connected to the R&S FSV/A.
Data Input and Output