R&S FSV3000 Series - Page 477

Common Analysis and Display Functions
R&S
®
FSVA3000/ R&S
®
FSV3000
477User Manual 1178.8520.02 ─ 01
This setting does not have any effect on limit lines that are defined by absolute values
for the x-axis.
Remote command:
CALCulate<n>:LIMit<li>:CONTrol:OFFSet on page 1045
Y-Offset
Shifts a limit line that has relative values for the y-axis (levels or linear units such as
volt) vertically.
This setting does not have any effect on limit lines that are defined by absolute values
for the y-axis.
Remote command:
CALCulate<n>:LIMit<li>:LOWer:OFFSet on page 1047
CALCulate<n>:LIMit<li>:UPPer:OFFSet on page 1050
Create New Line
Creates a new limit line.
Edit Line
Edit an existing limit line configuration.
Copy Line
Copy the selected limit line configuration to create a new line.
Remote command:
CALCulate<n>:LIMit<li>:COPY on page 1053
Delete Line
Delete the selected limit line configuration.
Remote command:
CALCulate<n>:LIMit<li>:DELete on page 1053
Disable All Lines
Disable all limit lines in one step.
Remote command:
CALCulate<n>:LIMit<li>:STATe on page 1053
Limit Line Details
Access: "Overview" > "Analysis" > "Lines" > "Limit Lines" > "New" / "Edit" / "Copy To"
or: [LINES] > "Line Config" > "Limit Lines" > "New" / "Edit" / "Copy To"
Display and Limit Lines