R&S FSV3000 Series - Page 759

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
759User Manual 1178.8520.02 ─ 01
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
[SENSe:]POWer:ACHannel:FILTer[:STATe]:ALTernate<ch> <State>
This command turns the weighting filter for an alternate channel on and off.
Suffix:
<ch>
.
1..n
Alternate channel number
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See " Weighting Filters " on page 166
See " Weighting Filters " on page 177
[SENSe:]POWer:ACHannel:FILTer[:STATe]:CHANnel<ch>
<State>
This command turns the weighting filter for a transmission channel on and off.
Suffix:
<ch>
.
1..n
Tx channel number
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See " Weighting Filters " on page 166
14.5.3.4 Selecting the Reference Channel
The following commands define the reference channel for relative ACLR measure-
ments.
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE....................................................... 759
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO................................................759
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual............................................. 760
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE
Usage:
Event
Manual operation: See "Setting a fixed reference for Channel Power measure-
ments ( Set CP Reference )" on page 163
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO <RefChannel>
This command selects the reference channel for relative measurements.
Configuring and Performing Measurements