R&S FSV3000 Series - Page 804

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
804User Manual 1178.8520.02 ─ 01
<li> 1..n
Power class for which the limit is defined.
Parameters:
<Level> Absolute limit at the stop frequency of a SEM range to be used
in addition to the relative limit if the MAX function is enabled (see
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:
RELative:STOP:FUNCtion on page 804).
Range: -400 to 400
*RST: -13
Default unit: dBm
Example:
SENSe:ESPectrum:RANGe:LIMit:RELative:STOP:
ABSolute -15
For a detailed example see Chapter 14.5.6.11, "Example: SEM
Measurement", on page 823.
Manual operation: See " Rel Limit Start / Stop <n> " on page 225
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:STOP:FUNCtion
<Function>
This command enables the use of a function when defining the relative limit for a SEM
range.
Suffix:
<sb>
.
1..n
<ri> 1..n
Selects the SEM range.
<li> 1..n
Power class for which the limit is defined.
Parameters:
<Function> OFF | MAX
Defines the function to be used to determine the relative limit
line stop value
MAX
The maximum of the relative and the absolute level is used as
the limit stop value. Use the [SENSe:]ESPectrum<sb>:
RANGe<ri>:LIMit<li>:RELative:STOP and [SENSe:
]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:
STOP:ABS commands to define these values.
OFF
No function is used, the relative limit line is defined by a fixed
relative stop value. Use the [SENSe:]ESPectrum<sb>:
RANGe<ri>:LIMit<li>:RELative:STOP command to define
this value.
*RST:
OFF
Configuring and Performing Measurements