Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
807User Manual 1178.8520.02 ─ 01
Suffix:
<sb>
.
1..n
Sub block in a Multi-SEM measurement
<ri> 1..n
Selects the measurement range.
Parameters:
<SweepTime> Sweep time.
The range depends on the ratios of the span to the RBW and
the RBW to the VBW. Refer to the data sheet for more informa-
tion.
Default unit: s
Manual operation: See " Sweep Time " on page 224
[SENSe:]ESPectrum<sb>:RANGe<ri>:SWEep:TIME:AUTO
<State>
This command turns automatic selection of the sweep time for a SEM range on and
off.
In case of high speed measurements, the sweep time has to be identical for all ranges.
Suffix:
<sb>
.
1..n
<ri> 1..n
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
ESP:RANG3:SWE:TIME:AUTO OFF
Deactivates the sweep time auto mode for range 3.
Manual operation: See " Sweep Time Mode " on page 223
[SENSe:]ESPectrum<sb>:RANGe<ri>:TRANsducer <Transducer>
This command selects a transducer factor for a SEM range.
Note that
●
the transducer must cover at least the span of the range
●
the x-axis has to be linear
●
the unit has to be dB
Suffix:
<sb>
.
1..n
Sub block in a Multi-SEM measurement
<ri> 1..n
Selects the measurement range.
Configuring and Performing Measurements
To Next Page
Loading...
