R&S FSV3000 Series - Page 224

Measurements and Results
R&S
®
FSVA3000/ R&S
®
FSV3000
224User Manual 1178.8520.02 ─ 01
For details on the sweep time mode, see Chapter 8.5.1.7, "How Long the Data is Mea-
sured: Sweep Time ", on page 381
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<ri>:SWEep:TIME:AUTO on page 807
Sweep Time
Sets the sweep time value for the range.
For details on the sweep time, see Chapter 8.5.1.7, "How Long the Data is Measured:
Sweep Time ", on page 381
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<ri>:SWEep:TIME on page 806
Ref Level
Sets the reference level for the range.
For details on the reference level, see Chapter 8.4.1.1, "Reference Level",
on page 366.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<ri>:RLEVel on page 806
RF Att Mode
Activates or deactivates the auto mode for RF attenuation.
For details on attenuation, see Chapter 8.4.1.2, "RF Attenuation", on page 368.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<ri>:INPut:ATTenuation:AUTO on page 799
RF Attenuation
Sets the attenuation value for the range.
For details on attenuation, see Chapter 8.4.1.3, "Scaling", on page 368.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<ri>:INPut:ATTenuation on page 798
Preamp
Switches the preamplifier on or off.
For details on the preamplifier, see " Preamplifier " on page 372.
Remote command:
[SENSe:]ESPectrum<sb>:RANGe<ri>:INPut:GAIN:STATe on page 799
Transducer Factor
Sets a transducer for the specified range. You can only choose a transducer that fulfills
the following conditions:
●
The transducer overlaps or equals the span of the range.
●
The x-axis is linear.
●
The unit is dB.
For details on transducers, see Chapter 12.5.1, "Basics on Transducer Factors",
on page 592.
Spectrum Emission Mask (SEM) Measurement