R&S FSV3000 Series - Page 964

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
964User Manual 1178.8520.02 ─ 01
Suffix:
<n>
.
1..n
Window
Parameters:
<Mode> VIDeo
The logarithmic power values are averaged.
LINear
The power values are averaged before they are converted to
logarithmic values.
POWer
The power level values are converted into unit Watt prior to
averaging. After the averaging, the data is converted back into
its original unit.
*RST: VIDeo
Example:
AVER:TYPE LIN
Switches to linear average calculation.
Manual operation: See " Average Mode " on page 495
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion] <Detector>
Defines the trace detector to be used for trace analysis.
For details see "Mapping Samples to sweep Points with the Trace Detector"
on page 486.
Suffix:
<n>
.
Window
<t> Trace
Example:
DET POS
Sets the detector to "positive peak".
Manual operation: See " Detector " on page 494
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]:AUTO <State>
This command couples and decouples the detector to the trace mode.
Suffix:
<n>
.
Window
<t> Trace
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DET:AUTO OFF
The selection of the detector is not coupled to the trace mode.
Manual operation: See " Detector " on page 494
Analyzing Measurements (Basics)