R&S SMB100A - Page 378

Remote Control Commands
R&S
®
SMB100A
363Operating Manual 1407.0806.32 ─ 21
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:COLumn <Column>
Selects the separator between the frequency and level column of the ASCII table.
Parameters:
<Column> TABulator | SEMicolon | COMMa | SPACe
*RST: COMMa
Example:
LIST:DEXC:MODE EXP
selects that the list is exported into an ASCII file.
LIST:DEXC:AFIL:SEL '/var/list.csv'
determines ASCII file list.csv as destination for the list mode list
data.
LIST:DEXC:AFIL:SEP:COL TAB
defines a tabulator to separate the frequency and level values
pairs.
LIST:DEXC:AFIL:SEP:DEC DOT
selects the decimal separator dot.
LIST:DEXC:SEL '/var/list_imp'
determines the source file list_imp for export into the ASCII file
list.csv.
LIST:DEXC:EXEC
exports the list file data into the ASCII file.
Manual operation:
See "Column Separator- List Mode" on page 194
[:SOURce<hw>]:LIST:DEXChange:AFILe:SEParator:DECimal <Decimal>
Sets the decimal separator used in the ASCII data between '.' (decimal point) and ','
(comma) with floating-point numerals.
Parameters:
<Decimal> DOT | COMMa
*RST: DOT
Example: see [:SOURce<hw>]:LIST:DEXChange:AFILe:
SEParator:COLumn on page 363
Manual operation: See "Decimal Point - List Mode" on page 194
[:SOURce<hw>]:LIST:DEXChange:EXECute
Executes the import or export of the selected list file, according to the previously set
transfer direction with command [:SOURce<hw>]:LIST:DEXChange:MODE.
SOURce Subsystem