Renesas PG-FP6 V1.06

PG-FP6 V1.06 7. Usage of Communications Commands
R20UT4469EJ0800 Rev.8.00 Page 107 of 188
Oct.01.21
7.5.5 dlm command
Refers to the DLM state and causes a transition of the state.
Input format
'dlm' (<type>) ('unique' <authentication code>)
Description of the function
Refers to the DLM state of the target device and causes a transition of the state.
dlm <type>:
Specifies the DLM state.
SSD, NSECSD, DPL, LCK_DBG, LCK_BOOT, or RMA_REQ
unique
<authentication>:
Specifies this parameter when unique ID authentication is to proceed.
Example of usage
Example of Communication Software Terminal Display
>dlm
Request DLM
DLM state: SSD
PASS
DLM operation finished.
>dlm SSD
Transit DLM
DLM state: SSD
PASS
DLM operation finished.