Renesas PG-FP6 V1.06

PG-FP6 V1.06 7. Usage of Communications Commands
R20UT4469EJ0800 Rev.8.00 Page 106 of 188
Oct.01.21
7.5.2 clr command
Executes “Configuration clear”.
Input format
'clr'
Description of the function
Executes “Configuration clear”.
Remark: For details of the “Configuration clear”, refer to the user’s manual of the MCU.
Example of usage
Example of Communication Software Terminal Display
>clr
Configuration clear :
PASS
Configuration clear operation finished.
7.5.3 con command
Executes the processes from “transition to the flash memory programming mode” to “signature verification”.
Input format
'con'
Description of the function
Executes the processes from “transition to the flash memory programming mode” to “signature verification”.
In order to use this command, “manual” (off) must be set with the autocon command beforehand.
7.5.4 dcon command
Executes the process to end the flash memory programming mode.
Input format
'dcon'
Description of the function
Executes the process to end the flash memory programming mode. In order to use this command, "manual"
(off) must be set with the autocon command beforehand.