PG-FP6 V1.06 1. Overview
R20UT4469EJ0800 Rev.8.00 Page 19 of 188
Oct.01.21
1.Overview
The FP6 is a tool that is used to erase, write, and verify programs on a Renesas Electronics on-chip flash
memory MCU on the target system.
1.1 Features
• Standalone programming
• Programming through the dedicated FP6 Terminal GUI under PC control
• Selectable from among up to eight programming environments
• Specialized for use on production lines (command control via serial communication and remote control of
signals from external devices)
• Programming of a unique code to a designated area of flash memory
• The FP6 Manager allows the customization required in development and mass-production, such as
prevention of a programming operator from modifying the programming settings.
• Self-testing function
• Support for simultaneous programming by FP6 Gang Programmer gang programming GUI, with the use
of up to 12 PG-FP6 units*
1
• Enhancement of the FP6 Manager and the encryption of program files to improve security against theft*
2
• Compatibility with the PG-FP5 interface allows the utilization of setting files that were for use with the PG-
FP5.
Notes: 1. FP6 Terminal V1.03.00 or a later version
2. FP6 Terminal V1.04.00 or a later version
1.2 Supported MCUs
MCUs supported by the FP6 are listed on the Web page at the following link:
https://www.renesas.com/pg-fp6
To Next Page
Loading...
