PG-FP6 V1.06 7. Usage of Communications Commands
R20UT4469EJ0800 Rev.8.00 Page 96 of 188
Oct.01.21
7.4.14 selftest command
Executes a diagnostic test.
Input format
'selftest'
Description of the function
Executes a self-test to diagnose hardware faults.
Example of usage
Example of Communication Software Terminal Display
>selftest
***** CAUTION *****
Remove any plugs from Target- and Remote-Connector before starting.
Any hardware attached to those connectors may be damaged by this test !
***** CAUTION *****
Target- and Remote-connector unplugged ?
If yes, press 's' to start the test.
Otherwise, press 'n' to cancel the test: s
FPGA Test: PASS
Power Supply Test: PASS
Target- and Remote-Interface Test: PASS
Selftest PASSED.
To Next Page
Loading...
