PG-FP6 V1.06 6. Usage of the Remote Connector
R20UT4469EJ0800 Rev.8.00 Page 77 of 188
Oct.01.21
6.Usage of the Remote Connector
This chapter describes the usage of the remote connector.
The FP6 can be remotely controlled by connecting the remote connector and external control device.
Remote control can be used to operate and check programming and the display of PASS, BUSY or ERROR
from the external control device.
6.1 Remote Interface Mode
The remote interface has a standard mode and a bank mode.
The modes are switched by using [Operation Mode] of [FP6 Options].
For details of the mode setting, refer to section 4.4.2.6, [Programmer Setting].
• Standard mode
The same signals as the control buttons (NEXT, ENTER, and CANCEL) on the command menu of the
FP6 unit can be input.
• Bank mode
This mode allows inputting of the bank signals (BANK0 to BANK2) that indicate the programming area.
The control buttons (NEXT, ENTER, and CANCEL) will change their functions to those inputting bank
signals.
To Next Page
Loading...
