PG-FP6 V1.06 7. Usage of Communications Commands
R20UT4469EJ0800 Rev.8.00 Page 98 of 188
Oct.01.21
7.4.16 set_auth_id command
Changes the authentication ID code to a desired value.
Input format
'set_auth_id' <type> <id>
Description of the function
When the authentication ID code is changed from the value in the settings file, this command is used to
specify the type of authentication ID code for which the value is to be set as the desired ID code.
The settings for ID code which have been made with this command are maintained unless the following
operations proceed (the following operations disable the set ID).
• Executing the downprm or downset command
• Changing the active programming area (executing [START] with the progarea command, the operation of
the FP6 main unit, or in bank mode)
• Issuing a reset (with the res, version_up, or hwtest command)
• Turning off the power of the FP6 main unit
If the upset command is executed during retention of the settings of the ID code, the settings file is uploaded
with the set ID.
Type of the authentication ID code
id: Serial programming ID
cfpw: Password for code flash memory
dfpw: Password for data flash memory
oid: OCD ID
cid: Customer ID
cidb: Customer ID B
cidc: Customer ID C
dfid: Data flash ID
ctid: C-TEST ID
sifid: RHSIF ID
seckey: SECDBG Key
nonseckey: NONSECDBG Key
rmakey: RMA Key
Specifies the authentication ID value.
Example of usage
Example of Communication Software Terminal Display
set_auth_id seri 00112233445566778899AABBCCDDEEFF
To Next Page
Loading...
