Renesas PG-FP6 V1.06

PG-FP6 V1.06 7. Usage of Communications Commands
R20UT4469EJ0800 Rev.8.00 Page 121 of 188
Oct.01.21
7.5.27 sed command
Executes the endian setting.
Input format
'sed'
Description of the function
Executes the endian setting.
Example of usage
Example of Communication Software Terminal Display
>sed
Set Endianness
PASS
Set Endianness operation finished.
7.5.28 sid command
Sets the ID code and enables ID authentication in the serial programming mode.
Input format
'sid' (<ID Code>)
Description of the function
Sets the ID code and enables ID authentication in the serial programming mode.
ID Code: Specifies the ID code to be set by a hexadecimal number.
No option specified: Value of setting file downloaded is set.
Set the ID code with a size supported by the MCU.
If ID code with an unavailable size is specified, an error occurs.
Example of usage
Example of Communication Software Terminal Display
>sid 0123456789ABCDEF
Set Serial Programming ID
PASS
Set Progr. ID operation finished.