Ricoh Aficio MP C5000 Function Guide

Note that the settings you must configure will vary depending on your operating environment. For details
about network settings and configuration procedures, see "Network Settings Required to Use Network
TWAIN Scanner", Network and System Settings Guide.
1. Press the [User Tools/Counter] key, and then press [System Settings].
The System Settings screen appears.
2. Press the [Interface Settings] tab.
3. Press [Machine IPv4 Address] to specify the machine's IPv4 address.
To specify a static IPv4 address for this machine, press [Specify], and then enter the IPv4 address and
subnet mask.
To obtain an IPv4 address from a DHCP server automatically, press [Auto-Obtain (DHCP)].
4. Press [IPv4 Gateway Address], and then enter the IPv4 gateway address.
5. Press [Effective Protocol], and then make [IPv4] active.
• If an extended wireless LAN board (optional) is installed, press [LAN Type ]on the [Interface Settings]
tab, then press [Ethernet], and then configure the network settings.
Installing the TWAIN driver on a client computer
Install the TWAIN driver on your computer.
Before Using the Network TWAIN Scanner
139
7

Ricoh Aficio MP C5000 Specifications

General

Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Fax Resolution	200 x 200 dpi
Duplex Printing	Yes
Max Document Enlargement	400%
Max Document Reduction	25%
Print Speed	50 ppm
Resolution	1200 x 1200 dpi
Copy Speed	50 cpm
Paper Capacity	Maximum: 4, 400 sheets
Scanner Type	Flatbed, ADF
Connectivity	USB, Ethernet
Operating System Compatibility	Windows, Mac