6. Special Operations under Windows
This chapter describes how to print files directly from Windows, or print with Bluetooth devices.
Printing Files Directly from Windows
You can print files directly using Windows commands. For example, you can print PostScript files for
PostScript 3.
Windows 2000/XP/Vista, Windows Server 2003/2003 R2
You can print files directly using lpr, rcp ftp or sftp command.
Setup
Follow the procedure below to make network environment settings.
1. Enable TCP/IP with the control panel, and then set up the printer's network environment
about TCP/IP including IP addresses.
TCP/IP of the printer is set as default.
2. Install a TCP/IP in Windows to set up the network environment.
Consult the network administrator for the local setting information.
3. To print under Windows 2000/XP/Vista, Windows Server 2003/2003 R2, install “Printing
service for UNIX” as the network application.
• p.321 "Using DHCP"
Using a Host Name Instead of an IPv4 Address
When a host name is defined, you can specify a printer by host name instead of IP address. The host names
vary depending on the network environment.
When using DNS
Use the host name set to the data file on the DNS server.
When setting the IPv4 address of a printer using DHCP
Use the printer name on the configuration page as the host name.
311
To Next Page
Loading...
Need help?
General
