Programming the LDAP server
This section describes how to specify the LDAP server settings.
This function supports LDAP version 2.0 and 3.0.
Program the LDAP server to find e-mail destinations in the LDAP server Address Book directly.
This function is possible when sending scan files by e-mail using the scanner or fax function.
To start an LDAP search, make sure that the items listed below are set. For other items, check your
environment and make any necessary changes.
• Server Name
• Search Base
• Port Number
• Authentication
• Search Conditions
If [Kerberos Authentication] is selected be sure to set the "User Name", "Password", and the "Realm Name".
If [Digest Authentication] or [Cleartext Authentication] is selected be sure to set the "User Name" and
"Password".
To use the LDAP server in Administrator Tools, select [On] under [LDAP Search].
The LDAP version 2.0 does not support Digest Authentication.
To select Kerberos Authentication, a realm must be registered in advance.
Programming the LDAP server
This section describes how to program the LDAP server.
1. Press the [User Tools/Counter] key.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [ Next] twice.
5. Press [Program / Change / Delete LDAP Server].
6. Check that [Program / Change] is selected.
7. Select the LDAP server you want to program or change.
When programming the server, select [*Not Programmed].
8. Press [Change] under "Name".
9. Enter the name, and then press [OK].
10. Press [Change] under "Server Name".
1. System Settings
58
To Next Page
Loading...
Need help?
General
