8. Copy the fonts you want to install in [System Folder].
A confirmation message appears.
9. Click [OK].
The fonts are installed.
10. Restart the Mac OS.
Changing to EtherTalk
Follow the procedure below to configure to a Mac OS to use EtherTalk.
1. Open [Control Panel], and then double-click the AppleTalk icon.
2. On the [Connect via:] pop-up menu, click [Ethernet].
3. If you change zones, select a name on the [Current zone:] pop-up menu.
4. Close the AppleTalk control panel.
5. Restart the computer.
• The procedures used to configure Mac OS may vary depending on the Mac OS version. The following
describes how to configure Mac OS 9.1. If you are using a different version of Mac OS, use the
following procedures as a reference and see the manuals for your Mac OS version.
• Confirm the Connection to the Printer with TCP/IP.
• For information about installing applications required for EtherTalk, see the Mac OS manuals.
2. Mac OS Configuration
60
To Next Page
Loading...
Need help?
General
