5. Check that [Program / Change] is selected.
6. Select the user whose user code you want to change.
Press the name key, or enter the registered number using the number keys. You can search by the
registered name, fax number, folder name, e-mail address, or IP-Fax destination.
7. Press [Auth. Info].
8. Press [Change], and then enter the new user code using the number keys.
9. Press the [ ] key.
10. To change the available functions, press [Auth. Info], and then press [
Next] twice.
11. Press the key to select the functions to enable them.
Press the key to highlight it, and then the function is enabled. To cancel a selection, press the highlighted
key.
12. Press [OK].
13. Press [Exit].
14. Press the [User Tools/Counter] key.
• To change the name, key display and title, see "Registering Name".
• p.245 "Registering Names"
Deleting a User Code
This section describes how to delete a user code.
• After clearing the user code, the counter is automatically cleared.
1. Press the [User Tools/Counter] key.
5. Registering Addresses and Users for Facsimile/Scanner Functions
252
To Next Page
Loading...
Need help?
General
