Even if you select [Login Privilege] and log on to the machine, you cannot cancel a copy or print job
in progress if you are not authorized to use the copy and printer functions.
You can specify [Authenticate Current Job] only if [User Authentication Management] was specified.
• Login Privilege
• Access Privilege
• Off
Password Policy
This can be specified by the user administrator.
The password policy setting is effective only if [Basic Auth.] is specified.
This setting lets you specify [Complexity Setting] and [Minimum Character No.] for the password. By
making this setting, you can limit the available passwords to only those that meet the conditions
specified in [Complexity Setting] and [Minimum Character No.].
If you select [Level 1], specify the password using a combination of two types of characters selected
from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
If you select [Level 2], specify the password using a combination of three types of characters selected
from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
• Level 2
• Level 1
• Off
• Minimum Character No. (0)
@Remote Service
Communication via HTTPS for @Remote Service is disabled if you select [Prohibit].
• Prohibit
• Do not Prohibit
Update Firmware
This can be specified by the machine administrator.
Specify whether to allow firmware updates on the machine. Firmware update means having the service
representative update the firmware or updating the firmware via the network.
If you select [Prohibit], firmware on the machine cannot be updated.
If you select [Do not Prohibit], there are no restrictions on firmware updates.
• Prohibit
• Do not Prohibit
Change Firmware Structure
This can be specified by the machine administrator.
Specifying the Extended Security Functions
213
To Next Page
Loading...
Need help?
General
