• The SSL/TLS encrypted communication mode can also be specified using Web Image Monitor. For
details, see Web Image Monitor Help.
• p.34 "Logging on Using Administrator Authentication"
• p.35 "Logging off Using Administrator Authentication"
SNMPv3 Encryption
This can be specified by the network administrator.
When using SmartDeviceMonitor for Admin or another application to make various settings, you can
encrypt the data transmitted.
By making this setting, you can protect data from being tampered with.
For details about logging on and logging off with administrator authentication, see "Logging on Using
Administrator Authentication", "Logging off Using Administrator Authentication".
1. Press the [User Tools/Counter] key.
2. Press [System Settings].
3. Press [Interface Settings].
4. Press [Permit SNMPv3 Communication].
If the setting to be specified does not appear, press [ Next] to scroll down to other settings.
5. Press [Encryption Only].
6. Press [OK].
7. Press the [User Tools/Counter] key.
• To use SmartDeviceMonitor for Admin for encrypting the data for specifying settings, you need to
specify the network administrator's [Encryption Password] setting and [Encryption Key] in [SNMP
Authentication Information] in SmartDeviceMonitor for Admin, in addition to specifying [Permit
Protection Using Encryption
181
To Next Page
Loading...
Need help?
General
