Closing telnet
msh> logout
A confirmation message appears.
{yes|no|return}
Enter [yes], [no], or [return] as required, and then press the [Enter] key.
To save the changes and then close telnet, enter [yes].
To close telnet without saving any changes, enter [no].
To continue making changes, enter [return].
lpr
Use the “lpr” command to view and configure LPR settings.
View Setting
msh> lpr
Checking host name when deleting the job
msh> lpr chkhost {on|off}
• The default is “on”.
If “on” is selected, you can delete print jobs only from the IP address of the host that sent the print job.
If LPR is disabled, you can also delete print jobs sent from IP addresses other than that of the host.
Printer Error Detection Function
lpr prnerrchk {on|off}
• The default is “off”.
If you set this to “on”, the printer stops receiving data and will wait until the error is resolved before
continuing processing a job.
netware
Use the “netware” command to view and configure the NetWare settings such as the print server name or
file server name.
NetWare Printer Server Names
msh> netware pnamecharacter string
• Enter the NetWare print server name using up to 47 characters.
NetWare File Server Names
msh> netware fname character string
• Enter the NetWare file server name using up to 47 characters.
Remote Maintenance by telnet
179
To Next Page
Loading...
Need help?
General
