6. Press [Exit].
7. Press the [User Tools/Counter] key.
Using Web SmartDeviceMonitor Professional IS/Standard to Manage Log Files
For details about using Web SmartDeviceMonitor Professional IS/Standard to manage Log Files, see the
manual supplied with the Using Web SmartDeviceMonitor Professional IS/Standard.
Using Web Image Monitor to Manage Log Files
This can be specified by the machine administrator. For details about logging on and logging off with
administrator authentication, see "Logging on Using Administrator Authentication", "Logging off Using
Administrator Authentication".
You can specify the type of log recording and collection level on the control panel, and also perform log
encryption, delete all logs.
Specify Log Collect Settings
Specify collection log settings. The collection log levels are listed below.
Job Log Collect Level
[Level 1]
[User Settings]
Access Log Collect Level
[Level 1]
[Level 2]
[User Settings]
1. Open a Web browser.
2. Enter " http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The machine administrator can log on using the appropriate login user name and login password.
4. Click [Configuration], and then click [Logs] under "Device Settings".
5. Select "Collect Job Logs" to specify Job Log settings, or select "Collect Access Logs" to specify
Access Log settings, and then select [Active].
6. Managing Access to the Machine
154
To Next Page
Loading...
Need help?
General
