File Transfer
This section describes the user tools in the File Transfer menu under System Settings.
Delivery Option
Enables or disables sending stored or scanned documents to the ScanRouter delivery server.
The default setting is [Off].
Specify this option when selecting whether or not to use the ScanRouter delivery software. If you do,
you will have to preregister I/O devices in the ScanRouter delivery software.
Capture Server IPv4 Address
Specify the capture server IPv4 address.
This setting appears when the File Format Converter is installed, and when the capture function is
being used by the ScanRouter delivery software.
Fax RX File Transmission
Specify how to deliver fax files received via the different lines.
This setting is displayed when the ScanRouter delivery software is using the delivery function.
• Setting per Line
• Line 1-3
• E-mail
• IP-Fax
The default setting is [Do not Deliver].
The lines appear according to the operating environment.
• RX File Delivery
Specifies whether or not received fax documents are sent to the ScanRouter delivery software
for each fax line.
The default setting is [Do not Deliver].
• Print at Deliver
Specify whether or not received fax documents sent to the ScanRouter delivery software should
also be printed at the same time.
The default setting is [Do not Print].
• File to Deliver
Specify whether all received fax documents or only received fax documents that include delivery
codes (documents with an ID or SUB/SEP codes) are sent to the ScanRouter delivery software.
The default setting is [All Files].
• Delivery Failure File
File Transfer
41
To Next Page
Loading...
Need help?
General
