Selecting Simple (Limitation)
If you select [Simple (Limitation)], you can specify clients for which printer job authentication is not required.
Specify [Parallel Interface: Simple], [USB: Simple] and the clients' IPv4 address range in which printer job
authentication is not required. Specify this setting if you want to print using unauthenticated printer drivers
or without any printer driver. Authentication is required for printing with non-specified devices.
If you select [Simple (Limitation)], you can print even with unauthenticated printer drivers or devices. Specify
this setting if you want to print with a printer driver or device that cannot be identified by the machine or if
you do not require authentication for printing. However, note that, because the machine does not require
authentication in this case, it may be used by unauthorized users.
1. Press [Simple (Limitation)].
2. Press [Change].
3. Specify the range in which [Simple (Limitation)] is applied to "Printer Job Authentication".
You can specify the IPv4 address range to which this setting is applied, and whether or not to apply
the setting to the parallel and USB interfaces.
4. Press [Exit].
5. Press [OK].
6. Press [Exit].
7. Press the [User Tools/Counter] key.
Authentication Information Stored in the Address Book
This can be specified by the user administrator. For details about logging on and logging off with
administrator authentication, see "Logging on Using Administrator Authentication", "Logging off Using
Administrator Authentication".
If you have specified User Authentication, you can specify access limits for individual users and groups of
users. Specify the setting in the Address Book for each user.
3. Users/Authentication and its Application
48
To Next Page
Loading...
Need help?
General
