Simultaneous Storage and Sending by Scan to
Folder
This section explains how to store a file and simultaneously send it by Scan to Folder.
1. Press [Store File].
2. Make sure that [Store to HDD + Send] is selected.
3. If necessary, specify the stored file's information, such as [User Name], [File Name], and
[Password].
For details, see "Specifying File Information for a Stored File".
4. Press [OK].
5. Specify the setting for sending the file by Scan to Folder, and then send the file.
For details about sending a file by Scan to Folder, see "Basic Procedure When Using Scan to Folder".
• Depending on the security setting, [Access Privileges] may appear instead of [User Name]. For
details about specifying [Access Privileges], consult the administrator.
• You can resend stored files by Scan to Folder. To resend stored files, select the files on the Select
Stored File screen, and then send them. For details, see "Sending a Stored File".
• p.97 "Specifying File Information for a Stored File"
• p.60 "Basic Procedure When Using Scan to Folder"
• p.106 "Sending a Stored File"
2. Sending Scan Files to Folders
76
To Next Page
Loading...
Need help?
General
