Protocol Set Protocol
ipx IPX
passwd
Use the “passwd” command to change the remote maintenance password.
Changing the password
msh> passwd
• Enter the current password.
• Enter the new password.
• Renter the new password to confirm it.
Changing the password of the administrators using the Supervisor
msh> passwd {Administrator ID}
• Enter the new password.
• Renter the new password to confirm it.
• Be sure not to forget or lose the password.
• The password can be entered using up to 32 alphanumeric characters. s are case-sensitive. For
example, “R” is not the same as “r”.
pathmtu
Use the “pathmtu” command to display and configure the PathMTU Discovery service function.
View settings
msh> pathmtu
Configuration
msh> pathmtu {on|off}
• The default is “on”.
• If the MTU size of the sent data is larger than the router's MTU, the router will declare it
impassable, and communication will fail. If this happens, selecting the “pathmtu” to “on”
optimizes the MTU size and prevents data output failure.
• Depending on the environment, information might not be obtained from the router, and
communication will fail. If this happens, select the “pathmtu” to “off”.
Remote Maintenance by telnet
181
To Next Page
Loading...
Need help?
General
