• For the Effective Protocol setting, check that the protocol you want to use is set to [Active].
• [LAN Type] is displayed when the wireless LAN interface board is installed.
• When both Ethernet and wireless LAN are connected, the selected interface takes precedence.
• p.33 "Interface Settings"
Wireless LAN
This section lists the settings required for using the network TWAIN Scanner a wireless LAN connection.
For details about how to specify the settings, see "Interface Settings".
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Necessary
Interface Settings/Network IPv4 Gateway Address As required
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Interface Settings/Network IPsec As required
Interface Settings/Network Domain Name As required
Interface Settings/Network WINS Configuration As required
Interface Settings/Network Effective Protocol Necessary
Interface Settings/Network LAN Type Necessary
Interface Settings/Network Permit SNMPv3 Communication As required
Interface Settings/Network Permit SSL / TLS Communication As required
Interface Settings/Network Host Name As required
Interface Settings/Wireless LAN Communication Mode Necessary
Interface Settings/Wireless LAN SSID Setting As required
Interface Settings/Wireless LAN Ad-hoc Channel As required
Interface Settings/Wireless LAN Security Method As required
2. Connecting the Machine
96
To Next Page
Loading...
Need help?
General
