• When scanning originals using [Custom Size], you cannot enter specific values in [Original Size] and
[Start Position]. To configure the scan area, specify [Scan Area] and [Start Position] first, and then
[Original Size].
How to set originals to scan them by custom size
This section explains how to place originals you want to scan at custom size.
Original Orientation setting
Under [Original Orientation], select [ ] or [ ] according to the orientation of your original. To
display [Original Orientation], on the initial scanner screen, press [Original Orientation]. For details,
see "Setting of Original Feed Type".
Placing an original
Place originals face up in the ADF; face down on the exposure glass.
Original Orientation is [ ]
Item Description
Placing an original in the ADF
Placing an original on the exposure
glass
Align the original, turn it rightward
or leftward, and then place it face
down on the exposure glass.
To Next Page
Loading...
Need help?
General
