• You can select an ID number between 1 and 3. You can select up to three ID numbers.
• You cannot use “255.255.255.255” as the DNS server address.
IPv6 DNS server configuration
The following command enables or disables the IPv4 DNS server address:
msh> dns “ID” server6 “server address”
• You can register IPv6 DNS Server address.
• The selectable ID number is between 1 and 3. You can select up to 3 ID.
Dynamic DNS function setting
msh> dns “interface_name” ddns {on|off}
• You can set the dynamic DNS function “active” or “inactive”.
• {on} means “active” and {off} means “inactive”.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Specifying the record overlap operation
msh> dns overlap {update|add}
• You can specify operations performed when records overlap.
• update: To delete old records and register new records.
• add: To add new records and store the old records.
• When CNAME overlaps, it is always changed, irrespective of settings.
CNAME registration
msh> dns cname {on|off}
• You can specify whether to register CNAME.
• {on} means “active” and {off} means “inactive”.
• The CNAME registered is the default name beginning with rnp. CNAME cannot be changed.
A records registration
msh> dns arecord {dhcp|own}
• dhcp: You can specify the method of registering an A record when the dynamic DNS function
is enabled and DHCP is used.
• own: To register an A record using the printer as the DNS client.
The DNS server address and the domain name already designated are used for the registration.
Remote Maintenance by telnet
173
To Next Page
Loading...
Need help?
General
