msh> set rfu6
msh> set ipp
msh> set ipp6
msh> set http
msh> set http6
msh> set bonjour
msh> set bonjour6
msh> set nbt
msh> set ssdp
msh> set ssh
msh> set sftp
msh> set sftp6
msh> set wsdev
msh> set wsdev6
msh> set wsprn
msh> set wsscn
msh> set rhpp
msh> set rhpp6
Configuration
• Enter “up” to enable protocol, and enter “down” to disable protocol.
You can set the protocol to “active” or “inactive”.
msh> set ipv4 {up|down}
• If you disable IPv4, you cannot use remote access after logging off. If you did this by mistake,
you can use the control panel to enable remote access via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http, bonjour, wsdev, and
sftp.
msh> set ipv6 {up|down}
• If you disable IPv6, you cannot use remote access after logging off. If you did this by mistake,
you can use the control panel to enable remote access via IPv6.
• Disabling IPv6 also disables lpr6, ftp6, rsh6, diprint6, ssl6, ipp6, http6, bonjour6, wsdev6, and
sftp6.
msh> set ipsec {up|down}
msh> set appletalk {up|down}
msh> set netware {up|down}
Remote Maintenance by telnet
185
To Next Page
Loading...
Need help?
General
